新闻中心

If you love your car, you have to understand and cherish it. Proper maintenance and repair will also escort you safely. Here are some tips for cleaning motorcycle parts to make motorcycle parts look new.

1. How to eliminate the cracking of motorcycle shell?

The probability of cracking the shell is that the paint surface of motorcycles sprayed with metallic paint and vehicles newly sprayed with paint will have a little unusually fine cracks. At the beginning, a small piece seeped into a large area, which was mainly caused by improper maintenance! Waxing can prevent these signs.

2. Why does the car paint oxidize? How to deal with it?

It's easy. When the car paint is illuminated by ultraviolet light, the color tone will be darker and lighter. In case of paint oxidation, just stop covering the paint by coating or crystal plating on schedule, which can not only reduce oxidation, but also prevent small scratches.

3. How do I get rid of the old decals stuck to the motorcycle?

On a whim, a little sticker is pasted on the motorcycle. After the wind, spring and rain, and the sun burst, some body decals often become old and hairy, but it's difficult for you to take it off. What should I do?

A good way to share: first soak the decal in water for about 301 min to make it wet, then dip the rubber used for drawing with a little washing powder solution, rub it on the decal, and after a while, the decal and a little dirt will be rubbed into strips and fall off. Then wash the surface of the car with water.

4. How to renovate the rusty motorcycle chain?

Many people often change the seriously worn chain. In fact, the wear of the chain is only in one direction. There are four directions of a chain, which can be changed completely. Just open the chain pin, turn the chain around and reinstall it, just as the new chain is easy to use.

When both sides of the inner ring are worn, the chain can be disassembled and turned over to turn the inner ring into an outer ring, so that two new faces can continue to be used. When the four sides of the chain are completely worn, it is not too late to replace it.

In either case, take some time to clean the rear sprocket and spray some detergent on the rag. If it is very dirty, pour the detergent on it, and then carefully brush with a brush to let the chain pass over the brush. After cleaning, it's time to apply lubricant. Make it clear accordingly. We need to apply lubricant to this part, both sides of the chain and the overlapping part of the side gasket and the chain. Turn the wheel with your right hand and lubricate the inner side of the chain first.

5. How to clean and renovate some non-metallic parts?

Motorcycle parts are suitable for all kinds, including metal parts and non-metallic parts, and we often encounter a little non-metallic parts to clean. These parts cannot be cleaned with kerosene, diesel, gasoline and metal cleaning agent for cleaning metal parts, otherwise they will deteriorate and become invalid. The cleaning method shall be determined according to the material of the parts:

1. Rubber parts shall be cleaned with alcohol.

2. Parts made of foam plastics should be cleaned by washing powder or soapy water.

3. Leather parts are not suitable for washing with any cleaning solution. Just wipe them with a cloth.

4. Paper parts shall not be cleaned with water, but with a brush or in kerosene and diesel oil.

5. The clutch friction plate and brake shoe friction plate shall not be cleaned with kerosene, diesel oil or alkali solution, but shall be brushed with gasoline.